Search Catalog
 All Categories    Kaeser Blower Purge Dryers - KBD Series
All Categories > Aftercoolers and Dryers > Desiccant Dryers > Kaeser Blower Purge Dryers - KBD Series > Item # KBD 3600  

Item # KBD 3600

    Download PDF Download PDF   
    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites

Flow Capacities Maximum inlet flow capacities at various pressures:
To determine a dryer's inlet flow capacity at inlet pressures other than 100 psig, multiply the dryer's rated inlet flow (found in Table 1) by the multiplier from Table 2 that corresponds to the system pressure at the dryer inlet.
KAD Dew Point Options Meet ISO 8573.1 Air Quality Standards (Table 3)
Models KAD and KAD PS allow the user to select outlet pressure dew points corresponding to the four different ISO 8573.1 air quality classes.
KAD E models are preset to deliver the commonly used ISO 8573.1 Class 2 outlet pressure dew point.
Outlet flow capacities:
For dryers operating at less than maximum flow and using the Purge Economizer feature and/or operating at pressures other than 100 psig, contact factory for correct purge flow. -

Average Heater kW (fixed cycle) = (kW required to produce 280°F temperature rise) x (235 min. max heat time) / (240 min drying time)
Average Blower kW (fixed cycle) = (Blower kW) x (235 min. max heat time) / (240 min dryer time)
Average Dryer kW (fixed cycle) = (Average Heater kW) + (Average Blower kW)
Actual kW is normally much lower and proportional with the average annual water load presented to the dryer.



Product Family

Desiccant Dryers



Inlet Flow at 100 psig 100ºF

3600 scfm


85 in.


116 in.


134 in.

Connection Size (Inlet/Outlet)

6 in.

Connection Type (Inlet/Outlet)



12095 lbs

Nom. Heater

60 kW

Avg. Heater

42.0 kW

Pre-Filter (KOR Series)


High Temp After-Filter (HTA Series)


Desiccant Per Tower


Blower Flow Rate

614 scfm

Nom. Blower


Avg. Blower


Other Options

Dew point monitor
High humidity alarm

Insulation for heated desiccant air dryers

NEMA 4 low ambient protection packages

Parallel piped pre-filters and after-filters

Stainless steel or copper pilot and instrument air tubing and fittings


·  Inlet Pressure Correction Factor


(PDF, 137KB)